Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM
RM3210E _54 Brake _047516 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0245157 ELECTRONICALLY CONTROLLED BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  C1451  Motor Drive Permission Malfunction  


DESCRIPTION

If air bleeding has not been performed, the skid control ECU (brake booster with master cylinder assembly) stores DTC C1451 to prevent the entry of air due to pump motor operation.

DTC C1451 is stored when Motor Invalid is selected, the system will not return to normal until the air bleeding procedure is performed.

DTC No. Detection Item INF Code DTC Detection Condition Trouble Area Note
C1451 Motor Drive Permission Malfunction 1152 Either of the following is detected:
1.

Using the GTS, "Motor Invalid" of the "ECB Utility" has been performed.

2.

The brake booster with master cylinder assembly has been replaced.


Air bleeding not performed Electronically controlled brake system DTC
HINT:
·

The DTC is cleared when the conditions return to normal.

·

ECB: Electronically Controlled Brake System




DTC Detection Conditions: C1451 INF Code: 1152
Vehicle Condition
Pattern 1 Pattern 2

*: Electronically Controlled Brake System

Diagnosis Condition - - -
Malfunction Status Using the GTS, "Motor Invalid" of the "ECB* Utility" has been performed. ○ -
The brake booster with master cylinder assembly has been replaced. - ○
Detection Time - -
Number of Trips 1 trip 1 trip

HINT:

DTC will be output when conditions for either of the patterns in the table above are met.


PROCEDURE

1.PERFORM AIR BLEEDING
a.

Bleed the air from the brake system.

Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID>BLEEDING

HINT:

If air bleeding has been performed, this DTC will be cleared.



Result:
Proceed to
NEXT



NEXT

2.RECONFIRM DTC
2.RECONFIRM DTC
a.

Check if the same DTC is output.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

Result:
Result Proceed to
DTC C1451 is output. A
DTC C1451 is not output. B



A

PERFORM AIR BLEEDING AGAIN

B

END