Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › GRILLE SHUTTER SYSTEM
RM3210E _59 Vehicle Exterior _047542 EXTERIOR PANELS / TRIM _0249519 GRILLE SHUTTER SYSTEM U

EXTERIOR PANELS / TRIM  GRILLE SHUTTER SYSTEM  TERMINALS OF ECU  


CHECK SWING GRILLE ACTUATOR ASSEMBLY


a.

w/ Canister Pump Module

B438396N02
3.406,0.115 3.844,0.365 0.438,0.25 3.5,0.167 3.958,0.365 0.458,0.198 10 false A36

i.

Disconnect the A36 swing grille actuator assembly connector.


ii.

Measure the voltage and resistance according to the value(s) in the table below.

HINT:

Measure the values on the wire harness side with the connector disconnected.


Tester Connection Wiring Color Terminal Description Condition Specified Condition
A36-4 (+B) - Body ground SB - Body ground Auxiliary battery power supply Power switch off 11 to 14 V
A36-1 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω



b.

w/o Canister Pump Module

B438341N02
3.396,0.188 3.76,0.438 0.365,0.25 3.469,0.24 3.927,0.438 0.458,0.198 10 false A37

i.

Disconnect the A37 swing grille actuator assembly connector.


ii.

Measure the voltage and resistance according to the value(s) in the table below.

HINT:

Measure the values on the wire harness side with the connector disconnected.


Tester Connection Wiring Color Terminal Description Condition Specified Condition
A37-1 (+B) - Body ground SB - Body ground Auxiliary battery power supply Power switch off 11 to 14 V
A37-3 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω