Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM(w/ Occupant Classification System) › from 2016.08
RM3210E _58 Vehicle Interior _047538 SEAT BELT _0244926 SEAT BELT WARNING SYSTEM(w/ Occupant Classification System) W

SEAT BELT  SEAT BELT WARNING SYSTEM(w/ Occupant Classification System)  CUSTOMIZE PARAMETERS  


CUSTOMIZE SEAT BELT WARNING SYSTEM


HINT:

The following items can be customized.


NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Be sure to make a note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.

·

These buzzers should be on for safe driving. Perform this procedure only if it is necessary to set the buzzer to off (disabled).



a.

Customizing with the GTS

i.

Connect the GTS to the DLC3.


ii.

Turn the power switch on (IG).


iii.

Turn the GTS on.


iv.

Enter the following menus: Customize Setting / Warning.


v.

Select the setting by referring to the table below.

Warning
Tester Display Description Default Setting ECU
Driver Side Seatbelt Warning Buzzer Enables sounding of the driver seat belt warning buzzer ON 0:OFF,1:ON Combination Meter Assembly (Meter circuit plate)
Front Passenger Side Seatbelt Warning Buzzer Enables sounding of the front passenger seat belt warning buzzer ON 0:OFF,1:ON Combination Meter Assembly (Meter circuit plate)
Rear Seatbelt Warning Buzzer Function to sound the rear seat belt warning buzzer ON 0:OFF,1:ON Combination Meter Assembly (Meter circuit plate)
50006 7
HINT:

These settings are only valid when the vehicle is driven at 20 km/h (12 mph) or more.