Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM(for Radio and Display Type) › from 2016.08
RM3210E _56 Audio / Visual / Telematics _047511 NAVIGATION / MULTI INFO DISPLAY _0239522 NAVIGATION SYSTEM(for Radio and Display Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Radio and Display Type)  Microphone Circuit between Radio Receiver and Extension Module  


DESCRIPTION

This circuit sends a microphone voice signal from the navigation ECU to the radio and display receiver assembly.

Using this circuit, the navigation ECU disables the microphone function of the radio and display receiver assembly to receive a microphone voice signal from the telephone microphone assembly.

WIRING DIAGRAM

E277822E04
1.146,0.552 1.76,0.75 0.615,0.198 10 false MCO+ 1.156,0.969 1.771,1.167 0.615,0.198 10 false MCO- 1.125,1.396 1.74,1.594 0.615,0.198 10 false SGND 1.625,0.427 2.24,0.625 0.615,0.198 10 false 5 1.625,0.865 2.24,1.063 0.615,0.198 10 false 6 1.615,1.271 2.229,1.469 0.615,0.198 10 false 1 3.271,1.229 4.01,1.427 0.74,0.198 10 false (Shielded) 5.625,0.542 6.24,0.74 0.615,0.198 10 false MIC+ 5.625,0.979 6.24,1.177 0.615,0.198 10 false MIC- 5.385,0.438 6,0.635 0.615,0.198 10 false 16 5.385,0.854 6,1.052 0.615,0.198 10 false 17 5.385,1.281 6,1.479 0.615,0.198 10 false 18 0.448,1.844 1.063,2.042 0.615,0.198 10 false e2 0.448,2.021 2.156,2.396 1.708,0.375 10 false Radio and Display Receiver Assembly 5.49,1.865 6.104,2.063 0.615,0.198 10 false e3 5.49,2.021 6.583,2.219 1.094,0.198 10 false Navigation ECU 5.615,1.406 6.229,1.604 0.615,0.198 10 false SGND

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NAVIGATION ECU)
a.

Disconnect the e2 radio and display receiver assembly connector.


b.

Disconnect the e3 navigation ECU connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
e2-5 (MCO+) - e3-16 (MIC+) Always Below 1 Ω
e2-6 (MCO-) - e3-17 (MIC-) Always Below 1 Ω
e2-1 (SGND) - e3-18 (SGND) Always Below 1 Ω
e2-5 (MCO+) or e3-16 (MIC+) - Body ground Always 10 kΩ or higher
e2-6 (MCO-) or e3-17 (MIC-) - Body ground Always 10 kΩ or higher
e2-1 (SGND) or e3-18 (SGND) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR