PRECAUTION
Precautions · Vehicles built Jan 2007 – Jul 2007
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008 from Aug 2008
| 1.TROUBLESHOOTING PRECAUTION |
- When there are malfunctions in the contact points of the terminals or installation problems with any parts, removal and installation of the suspected problem parts may return the system to its normal condition either entirely or temporarily.
- In order to determine the malfunctioning area, be sure to check the conditions at the time the malfunction occurred such as by DTC output and freeze frame data output, and record it before disconnecting each connector or removing and installing parts.
- Since the vehicle stability control system may be influenced by malfunctions in other systems, be sure to check for DTCs in the other systems.
- Be sure to remove and install the ABS and TRACTION actuator and each sensor with the ignition switch off unless specified in the inspection procedures.
- When removing and installing the ABS and TRACTION actuator and each sensor, be sure to check that the normal display is output during a test mode inspection and a DTC output inspection after reinstalling all the parts.
- After replacing the ABS and TRACTION actuator and/or yaw rate sensor, be sure to perform yaw rate and deceleration sensor zero point calibration (Click here).
- Perform zero point calibration of the yaw rate sensor for 4WD vehicles by connecting terminals TS and CG of the DLC3 (Click here).
- The CAN communication system is used for data communication between the skid control ECU, the steering sensor and the yaw rate sensor (the deceleration sensor is included). If there is trouble in the CAN communication line, the DTC of the communication line is output.
- If the DTC of the CAN communication line is output, repair the malfunction in the communication line and then troubleshoot the vehicle stability control system.
- Since a CAN communication line has its own length and route, it cannot be repaired temporarily with a bypass wire, etc.
| 2.IGNITION SWITCH EXPRESSIONS |
- HINT:
- The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
Expression
Ignition Switch (position)
Engine Switch (condition)
Ignition Switch off
LOCK
Off
Ignition Switch on (IG)
ON
On (IG)
Ignition Switch on (ACC)
ACC
On (ACC)
Engine Start
START
Start