DTC CHECK / CLEAR
Troubleshooting · Vehicles built Jan 2007 – Jul 2007
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007
| CHECK DTC (When Using Intelligent Tester) |
Connect the intelligent tester to the DLC3.

Turn the ignition switch on (IG).
Read the DTCs by following the prompts on the tester screen.
- HINT:
- Refer to the intelligent tester operator's manual for further details.
| CLEAR DTC (When Using Intelligent Tester) |
Connect the intelligent tester to the DLC3.

Turn the ignition switch on (IG).
Operate the intelligent tester to clear the codes.
- HINT:
- Refer to the intelligent tester operator's manual for further details.
| CHECK DTC (When not Using Intelligent Tester) |
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

- SST
- 09843-18040
Turn the ignition switch on (IG).
w/o Multi-information display: Read DTCs from the ABS warning light on the combination meter.
w/ Multi-information display: Read DTCs from the ABS warning light and the multi-information display on the combination meter.
- HINT:
- If the ABS warning light does not blink, perform the relevant troubleshooting procedures. The relevant troubleshooting procedures are instructed in the sections listed in the table below.
Section Title
See Page
ABS Warning Light does not Come ON
Click here
TC and CG Terminal Circuit
Click here
- As an example, the illustration below shows the blinking patterns of the normal system code and trouble codes 11 and 21 for the ABS, and display of the normal system code and trouble code 11 and 21 for the ABS on the multi information display. As an example, the blinking patterns of the normal system code and DTCs 11 and 21 are shown below.


- DTCs are explained in "DIAGNOSTIC TROUBLE CODE CHART" (Click here).
- If the ABS warning light does not blink, perform the relevant troubleshooting procedures. The relevant troubleshooting procedures are instructed in the sections listed in the table below.
After completing the check, disconnect SST from terminals 13 (TC) and 4 (CG) of the DLC3, and turn the ignition switch off.
- HINT:
- If 2 or more malfunctions are detected at the same time, the lowest numbered DTC is displayed first.
| CLEAR DTC (When not Using Intelligent Tester) |
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

- SST
- 09843-18040
Turn the ignition switch on (IG).
Clear the DTCs stored in the skid control ECU by depressing the brake pedal 8 times or more within 5 seconds.

Check that the warning light blinks in the normal system code pattern.
Remove SST from the terminals of the DLC3.
Turn the ignition switch off.
- HINT:
- Clearing the DTCs cannot be performed by removing the battery cable or ECU-IG1 fuse.
| END OF DTC CHECK/CLEAR |
Turn the ignition switch on (IG).
Check that the ABS warning light goes off within approximately 3 seconds.
Turn the ignition switch off.