2005-2008 RAV4 · Service Manual BRAKE

ABS Warning Light Remains ON

Circuit diagnosis · Vehicles built from Aug 2007

Versions by build date: Nov 2005 – Jul 2007 from Aug 2007

DESCRIPTION

If any of the following conditions are detected, the ABS warning light remains on:
  1. The ECU connectors are disconnected from the skid control ECU.
  2. There is a malfunction in the skid control ECU internal circuit.
  3. There is an open or short in the wire harness between the combination meter and the skid control ECU.

HINT:
The intelligent tester may not be used when there is a malfunction in the skid control ECU.


WIRING DIAGRAM

C131829E01
C131830E01

INSPECTION PROCEDURE


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication system DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
REPAIR CAN COMMUNICATION SYSTEM
A


2. INSPECT SKID CONTROL ECU CONNECTOR
  1. Check if the skid control ECU connector is properly installed.

    OK:
    The skid control ECU connector is properly installed.



NG
CONNECT CONNECTOR TO ECU SECURELY
OK


3. CHECK WIRE HARNESS (SKID CONTROL ECU - BATTERY AND BODY GROUND)

  1. C117862E11
    Disconnect the A27 ECU connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    A27-2 (GND1) - Body ground
    Below 1 Ω
    A27-24 (GND2) - Body ground
    Below 1 Ω

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A27-25 (IG) - Body ground
    Ignition switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (ABS WARNING LIGHT)
  1. Select the Active Test, generate a control command, and then check that the ABS warning light operates.

    Skid control ECU 
    Item (Display)
    Test Details
    Diagnostic Notes
    ABS Warning Lamp
    Turns ABS warning light / ON or OFF
    Observe combination meter

    OK:
    The ABS warning light is turned on or off.

HINT:
When the ABS warning light remains illuminated, opens in the wire harness of the combination meter or abnormalities in the meter circuit should be considered.



NG
CHECK METER / GAUGE SYSTEM
OK

REPLACE BRAKE ACTUATOR ASSEMBLY


← ABS Warning Light Remains ON (Nov 2005 – Jul 2007)ABS Warning Light does not Come ON (Nov 2005 – Jul 2007) →