2005-2008 RAV4 · Service Manual BRAKE

ABS Warning Light does not Come ON

Circuit diagnosis · Vehicles built Aug 2007 – Jul 2008

Versions by build date: Nov 2005 – Jul 2007 Aug 2007 – Jul 2008 from Aug 2008

WIRING DIAGRAM

Refer to the ABS warning light circuit (Click here).

INSPECTION PROCEDURE


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication system DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
REPAIR CAN COMMUNICATION SYSTEM
A


2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (ABS WARNING LIGHT)
  1. Select the Active Test, generate a control command, and then check that the ABS warning light operates.

    Skid control ECU 
    Item (Display)
    Test Details
    Diagnostic Note
    ABS Warning Lamp
    Turns ABS warning light / ON or OFF
    Observe combination meter

    OK:
    The ABS warning light turns on or off.



NG
CHECK METER / GAUGE SYSTEM
OK

REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY


← ABS Warning Light does not Come ON (Nov 2005 – Jul 2007)ABS Warning Light does not Come ON (from Aug 2008) →