TC and CG Terminal Circuit
Circuit diagnosis · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007
DESCRIPTION
Connecting terminals TC and CG of the DLC3 causes the skid control ECU to display 2-digit DTCs by flashing the ABS warning light.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK DLC3 (TC VOLTAGE) |
 |
- Turn the ignition switch on (IG).
Measure the voltage of the DLC3.
- Standard voltage:
Tester Connection
|
Specified Condition
|
E16-13 (TC) - Body ground
|
10 to 14 V
|
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 2. CHECK CAN COMMUNICATION SYSTEM |
 |
Check the DTC (Click here).
Result
Result
|
Proceed to
|
DTC is not output
|
A
|
DTC is output
|
B
|
|
B |
 |
|
| REPAIR CIRCUITS INDICATED BY OUTPUT DTCS |
|
|
| A |
|
 |
|
| REPLACE BRAKE ACTUATOR ASSEMBLY |
|
| 3. CHECK WIRE HARNESS (DLC3 - ECM AND BODY GROUND) |
 |
- Turn the ignition switch off.
Disconnect the A12 ECM connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
|
Specified Condition
|
E16-13 (TC) - A12-27 (TC)*1
|
Below 1 Ω
|
E16-13 (TC) - A12-26 (TC)*2
|
Below 1 Ω
|
A12-27 (TC)*1 - Body ground
|
10 kΩ or higher
|
A12-26 (TC)*2 - Body ground
|
10 kΩ or higher
|
- HINT:
- *1: for 2AZ-FE, 1AZ-FE
- *2: for 2AD-FTV
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS AND CONNECTOR |
|
|
| OK |
|
 |
|
| 4. CHECK WIRE HARNESS (DLC3 - BODY GROUND) |
 |
- Measure the resistance of the DLC3.
- Standard resistance:
Tester Connection
|
Specified Condition
|
E16-4 (CG) - Body ground
|
Below 1 Ω
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS AND CONNECTOR |
|
|
| OK |
|
 |
|
| 5. CHECK CAN COMMUNICATION SYSTEM |
 |
Check if the CAN communication DTC is output (Click here).
Result
Result
|
Proceed to
|
DTC is not output
|
A
|
DTC is output
|
B
|
|
B |
 |
|
| REPAIR CIRCUITS INDICATED BY OUTPUT DTCS |
|
|
| A |
|
 |
|
| REPLACE BRAKE ACTUATOR ASSEMBLY |
|