DIAGNOSIS SYSTEM
Troubleshooting · Vehicles built from Aug 2007
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007
| EURO-OBD (EUROPE) |
Euro-OBD regulations require that the vehicle's on-board computer illuminate the Malfunction Indicator Lamp (MIL) on the instrument panel when the computer detects a malfunction in:
![]() ![]() |
The emission control system components
The power train control components (which affect vehicle emissions)
The computer



In addition, if the applicable Diagnostic Trouble Codes (DTCs) prescribed by ISO 15765-4 are recorded in the ECM memory. If the malfunction does not reoccur in 3 consecutive trips, the MIL turns off automatically but the DTCs remain recorded in the ECM memory.- HINT:
- When a problem is detected, "CHECK ENGINE SYSTEM" appears in the multi-information display (the combination's MIL does not illuminate).
The scan tool displays DTCs, the freeze frame data and a variety of engine data.
The DTCs and freeze frame data can be erased the scan tool (Click here).
| M-OBD (EXCEPT EUROPEAN SPEC.) |
OBD regulations require that the vehicle's on-board computer illuminate the MIL on the instrument panel when the computer detects a malfunction in:
![]() ![]() |
The emission control system/components
The power train control components (which affect vehicle emissions)
The computer
In addition, the applicable DTCs are recorded in the ECM memory. If the malfunction does not recur in 3 consecutive trips, the MIL turns off automatically but the DTCs remain recorded in the ECM memory.
| NORMAL MODE AND CHECK MODE |
| 2-TRIP DETECTION LOGIC |


| DLC3 (Data Link Connector 3) |
- HINT:
- Connect the cable of an intelligent tester to the DLC3, turn the ignition switch on (IG) and attempt to use the tester. If the display indicates that a communication error has occurred, there is a problem either with the vehicle or with the tester.
- If communication is normal when the tester is connected to another vehicle, inspect the DLC3 of the original vehicle.
- If communication is still not possible when the tester is connected to another vehicle, the problem may be in the tester itself. Consult the Service Department listed in the tester's instruction manual.
| Symbol |
Terminal No. |
Name |
Reference terminal |
Result |
Condition |
| SIL |
7 |
Bus "+" line |
5 - Signal ground |
Pulse generation |
During transmission |
| CG |
4 |
Chassis ground |
Body ground |
1Ω or less |
Always |
| SG |
5 |
Signal ground |
Body ground |
1Ω or less |
|
| BAT |
16 |
Battery positive |
Body ground |
9 to 14 V |
|
| CANH |
6 |
CAN "High" Line |
14 - CANL |
54 to 69 Ω |
Ignition switch off* |
| Battery positive |
1 MΩ or higher |
||||
| 4 - CG |
200 Ω or higher |
||||
| CANL |
14 |
CAN "Low" Line |
Battery positive |
1 MΩ or higher |
|
| 4 - CG |
200 Ω or higher |
- NOTICE:
- *: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, other switches and doors.
| INSPECT BATTERY VOLTAGE |
- Battery Voltage:
- 11 to 14 V
| CHECK MIL |
Check that the MIL illuminate when the ignition switch is turned on (IG).
If the MIL does not illuminate, there is a problem in the MIL circuit (Click here).When the engine is started, the MIL should turn off.
