2005-2008 RAV4 · Service Manual ENGINE

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from Jan 2007

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007

NOTICE:
When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze frame data that were recorded in normal mode are erased. Before changing modes, always check and make a note of any DTCs and freeze frame data.

HINT:
  1. DTCs which are stored in the ECM can be displayed on the intelligent tester. The intelligent tester can display both current and pending DTCs.
  2. Malfunctions that were not detected a second time by the ECM during the second driving cycle are stored as pending DTCs.
  3. The pending DTCs are set when the malfunction is detected once.


CHECK DTC (Using intelligent tester)
B127990E01
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG) and turn the tester ON.

  3. Enter the following menus: Powertrain / Engine and ECT / DTC.

  4. Check the DTCs and freeze frame data, and then write them down.

  5. Check the details of the DTCs (Click here).


CLEAR DTC (Using intelligent tester)
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG) and turn the tester ON.

  3. Enter the following menus: Powertrain / Engine and ECT / DTC / Clear.

  4. Press the "YES" button.


CLEAR DTC (Without using intelligent tester)
  1. Perform either of the following operations.

    1. Disconnect the cable from the negative (-) battery terminal for more than 1 minute.

    2. Remove the EFI MAIN and ETCS fuses from the engine room No. 1 relay block (located inside the engine compartment) for more than 1 minute.

← DTC CHECK / CLEAR (Nov 2005 – Dec 2006)CHECK MODE PROCEDURE (Nov 2005 – Dec 2006) →