P0010 Camshaft Position "A" Actuator Circuit (Bank 1)
Diagnostic trouble codes · Vehicles built from Nov 2005
DESCRIPTION
- HINT:
- This DTC relates to the Oil Control Valve (OCV).


| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0010 |
Open or short in OCV circuit (1 trip detection logic) |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (OPERATE OCV) |
Connect the intelligent tester to the DLC3.
Start the engine and turn the tester ON.
Warm up the engine.
Select the following menu items: Powertrain / Engine and ECT / Active Test / Control the VVT System (Bank 1).
Check the engine speed while operating the Oil Control Valve (OCV) using the tester.
- OK:
Tester Operation
Specified Condition
OCV OFF
Normal engine speed
OCV ON
Engine idles roughly or stalls
(soon after OCV switched from OFF to ON)
|
|
||||
| NG | |
| 2. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY |
Disconnect the B17 OCV connector.

Measure the resistance between the terminals of the OCV.
- Standard resistance:
- 6.9 to 7.9 Ω at 20°C (68°F)
Reconnect the OCV connector.
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (OCV - ECM) |
Disconnect the B17 OCV connector.

Disconnect the B32 ECM connector.
Measure the resistance.
- Standard resistance (check for open):
Tester Connection
Specified Condition
OC1+ (B17-1) - OC1+ (B32-100)
Below 1 Ω
OC1- (B17-2) - OC1- (B32-123)
- Standard resistance (check for short):
Tester Connection
Specified Condition
OC1+ (B17-1) or OC1+ (B32-100) - Body ground
10 kΩ or higher
OC1- (B17-2) or OC1- (B32-123) - Body ground
Reconnect the OCV connector.
Reconnect the ECM connector.
|
|
||||
| OK | ||
| ||
