2005-2008 RAV4 · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Nov 2005

NOTICE:
  1. Perform the MAF meter inspection according to the procedures below.
  2. Only replace the MAF meter when the MAF value in the DATA LIST (with the engine stopped) is not within the normal operating range.


CHECK MASS AIR FLOW METER

  1. B127990E04
    Read the value using the intelligent tester (MAF).

    NOTICE:
    1. Turn off the engine.
    2. Perform the inspection with the vehicle indoors and on a level surface.
    3. Perform the inspection of the MAF meter while it is installed to the air cleaner case (installed to the vehicle).
    4. During the test, do not use the exhaust air duct to perform suction on the exhaust pipe.


    1. Turn the ignition switch on (IG).

    2. Turn the tester ON.

    3. Select the following menu items: Powertrain / Engine / Data List / MAF.

    4. Wait 30 seconds, and read the values on the intelligent tester.

      Standard condition:
      Less than 0.55 g/sec.

      1. If the result is not as specified, replace the MAF meter.

← COMPONENTS (from Nov 2005)REMOVAL (from Nov 2005) →