P0560 System Voltage
Diagnostic trouble codes · Vehicles built from Aug 2007
DESCRIPTION
The battery supplies electricity to the ECM even when the ignition switch is off. This power allows the ECM to store data such as DTC history, freeze frame data and fuel trim values. If the battery voltage falls below a minimum level, these memories are cleared and the ECM determines that there is a malfunction in the power supply circuit. When the engine is next started, the ECM illuminates the MIL and sets the DTC.| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0560 |
Open in ECM back-up power source circuit (1 trip detection logic) |
|
- HINT:
- If DTC P0560 is set, the ECM does not store other DTCs.
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air-fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction (Click here).
| 1. CHECK HARNESS AND CONNECTOR (EFI MAIN FUSE - ECM) |
Remove the EFI MAIN fuse from the engine room No. 1 relay block.

Disconnect the ECM connector.
Measure the resistance between the terminals.
- Standard resistance (Check for open):
Tester Connection
Specified Condition
Engine room No. 1 R/B EFI MAIN fuse terminal 2 - BATT (A12-20)
Below 1 Ω
- Standard resistance (Check for short):
Tester Connection
Specified Condition
Engine room No. 1 R/B EFI MAIN fuse terminal 2 or BATT (A12-20) - Body ground
10 kΩ or higher
Connect the ECM connector.
Reinstall the EFI MAIN fuse.
|
|
||||
| OK | |
| 2. INSPECT BATTERY |
Check that the battery is not depleted.
- OK:
- Battery is not depleted.
|
|
||||
| OK | |
| 3. CHECK BATTERY TERMINAL |
Check that the battery terminals are not loose or corroded.
- OK:
- Battery terminals are not loose or corroded.
|
|
||||
| OK | |
| 4. CHECK WHETHER DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the intelligent tester on.
Clear the DTCs (Click here).
Turn the intelligent tester off.
Start the engine and turn the intelligent tester on.
Select the following menu items: Powertrain / Engine and ECT / DTC.
Read the DTCs.
- Result:
Display (DTC Output)
Proceed to
P0560
A
No output
B
|
|
||||
| A | ||
| ||
