PRECAUTION
Precautions · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
- HINT:
- The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
Expression
Ignition Switch (position)
Engine Switch (condition)
Ignition Switch off
LOCK
Off
Ignition Switch on (IG)
ON
On (IG)
Ignition Switch on (ACC)
ACC
On (ACC)
Engine Start
START
Start
| 1.INJECTOR COMPENSATION CODE |
- HINT:
- Each injector has different fuel injection characteristics. In order to optimize fuel injection performance, the ECM compensates for these differences by adjusting the fuel injection duration of each injector according to its compensation code. Injector compensation codes are unique, 30-digit, alphanumeric values printed on the head portion of each injector.
- If an incorrect injector compensation code is input into the ECM, the engine may rattle or engine idling may become rough. In addition, engine failure may occur and the life of the engine may be shortened
- Each injector has different fuel injection characteristics. In order to optimize fuel injection performance, the ECM compensates for these differences by adjusting the fuel injection duration of each injector according to its compensation code. Injector compensation codes are unique, 30-digit, alphanumeric values printed on the head portion of each injector.
When an injector is replaced, the injector's compensation code must be input into the ECM (Click here).

When the ECM is changed, all of the existing injector compensation codes must be input into the new ECM (Click here).
| 2.DIFFICULT TO START ENGINE, ENGINE STALLING, OR BLACK SMOKE EMITTED |
Check if the customer's problem is described below. If so, refer to the troubleshooting section on the page given.
Engine is difficult to start or stalls (Click here).
Black smoke is emitted (Click here).
| 3.FOR USING INTELLIGENT TESTER |
- CAUTION:
- Observe the following items for safety reasons:
- Read its instruction manual before using the tester.
- Prevent the tester cable from being caught on the pedals, shift lever and steering wheel when driving with the tester connected to the vehicle.
- When driving the vehicle while using the tester for testing purposes, two persons are required. One drive the vehicle, and the other operates the tester.
- Observe the following items for safety reasons: