2005-2008 RAV4 · Service Manual ENGINE

MIL Circuit

Circuit diagnosis · Vehicles built Jan 2007 – Jul 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007

DESCRIPTION

If the ECM detects a malfunction, the MIL illuminates. The ECM then records the DTC in its memory.

WIRING DIAGRAM

C128792E01

INSPECTION PROCEDURE

NOTICE:
After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).


1. CHECK MIL CONDITION
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Use the table below to troubleshoot each problem symptom.

    Result:
    Condition
    Proceed to
    MIL remains ON
    A
    MIL is not illuminated
    B



B
Go to step 5
A


2. CHECK DTC
  1. Enter the following menus: Powertrain / Engine and ECT / DTC.

  1. Read pending DTCs.

    Result:
    Display (DTC Output)
    Proceed to
    No DTCs
    A
    Engine related DTCs
    B



A
GO TO DTC CHART
B


3. CHECK WIRE HARNESS

  1. A115671E13
    Disconnect the A12 ECM connector.

  1. Turn the ignition switch on (IG).

  1. Check that the MIL does not illuminate.

    OK:
    MIL does not illuminate.

  1. Reconnect the ECM connector.



OK
REPLACE ECM
NG


4. CHECK WIRE HARNESS (COMBINATION METER - ECM)
A127855E06
  1. Disconnect the E22 combination meter connector.

  1. Disconnect the A12 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance (Check for short):
    Tester Connection
    Specified Condition
    A12-12 (W) or E22-8 (EFI) - Body ground
    10 kΩ or higher

  1. Reconnect the combination meter connector.

  1. Reconnect the ECM connector.



OK
REPAIR OR REPLACE COMBINATION METER ASSEMBLY
NG

REPAIR OR REPLACE HARNESS AND CONNECTOR

5. CHECK IF MIL ILLUMINATES
  1. Check if the MIL is illuminated when the ignition switch is turned on (IG).

    OK:
    MIL illuminates.



OK
SYSTEM IS OK
NG


6. CHECK COMBINATION METER ASSEMBLY (MIL CIRCUIT)
  1. Check the combination meter circuit (Click here).

    OK:
    Combination meter circuit is normal.



NG
REPAIR OR REPLACE COMBINATION METER ASSEMBLY
OK

REPAIR OR REPLACE HARNESS AND CONNECTOR (COMBINATION METER - ECM)


← MIL Circuit (Nov 2005 – Dec 2006)MIL Circuit (from Aug 2007) →