MIL Circuit
Circuit diagnosis · Vehicles built from Aug 2007
Versions by build date: Jan 2007 – Jul 2007 from Aug 2007
DESCRIPTION
If the ECM detects a malfunction, the MIL illuminates. The ECM then records the DTC in its memory.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).
| 1. CHECK MIL CONDITION |
 |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Use the table below to troubleshoot each problem symptom.
- Result:
Condition
|
Proceed to
|
MIL remains ON
|
A
|
MIL is not illuminated
|
B
|
|
B |
 |
|
|
|
| A |
|
 |
|
| 2. CHECK DTC |
 |
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read pending DTCs.
- Result:
Display (DTC Output)
|
Proceed to
|
No DTCs
|
A
|
Engine related DTCs
|
B
|
|
A |
 |
|
|
|
| B |
|
 |
|
| 3. CHECK HARNESS AND CONNECTOR (CHECK FOR SHORT IN WIRE HARNESS) |
 |
- Disconnect the ECM connector.
Turn the ignition switch on (IG).
Check that the MIL does not illuminate.
- OK:
- MIL does not illuminate.
Reconnect the ECM connector.
|
OK |
 |
|
|
|
| NG |
|
 |
|
| 4. CHECK HARNESS AND CONNECTOR (COMBINATION METER - ECM) |
 |
- Disconnect the combination meter connector.
Disconnect the ECM connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance (Check for short):
Tester Connection
|
Specified Condition
|
A12-12 (W) or E22-8 (EFI) - Body ground
|
10 kΩ or higher
|
Reconnect the combination meter connector.
Reconnect the ECM connector.
|
OK |
 |
|
| REPAIR OR REPLACE COMBINATION METER ASSEMBLY |
|
|
| NG |
|
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
| 5. CHECK IF MIL ILLUMINATES |
 |
Check if the MIL is illuminated when the ignition switch is turned on (IG).
- OK:
- MIL illuminates.
|
OK |
 |
|
|
|
| NG |
|
 |
|
| 6. CHECK COMBINATION METER ASSEMBLY (MIL CIRCUIT) |
 |
Check the combination meter circuit (Click here).
- OK:
- Combination meter circuit is normal.
|
NG |
 |
|
| REPAIR OR REPLACE COMBINATION METER ASSEMBLY |
|
|
| OK |
|
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR (COMBINATION METER - ECM) |
|