2005-2008 RAV4 · Service Manual ENGINE

CHECK MODE PROCEDURE

Troubleshooting · Vehicles built Nov 2005 – Dec 2006

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007

HINT:
Check mode has a higher sensitivity to malfunctions and can detect malfunctions that normal mode cannot detect. Check mode can also detect the same malfunctions that normal mode can.
In check mode, the ECM will detect faults and set DTCs more effectively than in normal mode.

NOTICE:
All the stored DTCs and freeze frame data are erased if: 1) the ECM is changed from normal mode to check mode or vice versa; or 2) the ignition switch is turned from on (IG) to on (ACC) or off during check mode.
Before changing modes, always check and note any stored DTCs and freeze frame data.


CHECK MODE PROCEDURE

  1. B127990E04
    Turn the ignition switch off.

  2. Make sure that the vehicle is in the following condition:

    1. Battery voltage is 11 V or more.

    2. Accelerator pedal is not depressed.

    3. Parking brake is OFF.

    4. Shift lever is in the N position.

    5. A/C switch is OFF.

  3. Connect the intelligent tester to the DLC3.

  4. Turn the ignition switch on (IG) and turn the tester ON.

  5. A076900E04
    Enter the following menus: Powertrain / Engine and ECT / Check Mode.

  6. Make sure that the MIL flashes as shown in the illustration.

  7. Start the engine (the MIL should turn OFF).

  8. Simulate the conditions of the malfunction described by the customer.

  9. Check the DTCs and freeze frame data using the tester.

  10. After checking for DTCs, inspect the appropriate circuits (Click here).

← DTC CHECK / CLEAR (from Jan 2007)CHECK MODE PROCEDURE (from Jan 2007) →