2005-2008 RAV4 · Service Manual ENGINE

BASIC INSPECTION

Troubleshooting · Vehicles built from Nov 2005

When a malfunction cannot be confirmed by checking DTCs, troubleshooting should be performed on all circuits that are possible causes of the problem. However, in most cases, performing the basic engine check shown below can help you find the problem quickly and efficiently. Always perform this check first when troubleshooting the engine.

1.CHECK BATTERY VOLTAGE

    NOTICE:
    Check the battery voltage with the engine stopped and the ignition switch off.

    Standard voltage:
    Voltage
    Proceed to
    11 V or more
    OK
    Less than 11 V
    NG


NG.
OK

2.CHECK IF ENGINE CRANKS

    NG.
    OK

    3.CHECK AIR FILTER
    1. Visually check that the air filter is not excessively contaminated with dirt or oil.


    NG.
    OK

    4.CHECK FUEL QUALITY
    1. Check that only diesel fuel is present.

    2. Check that the fuel does not contain any impurities.


    NG.
    OK

    5.CHECK FUEL SYSTEM FOR AIR

      NG.
      OK

      6.CHECK FUEL PIPES AND HOSES
      1. Check that the fuel pipes and fuel hoses are not blocked, damaged, disconnected or bent.


      NG.
      OK

      7.CHECK FUEL FILTER FOR BLOCKAGE

        NG.
        OK

        8.CHECK ENGINE OIL

          NG.
          OK

          9.CHECK ENGINE COOLANT

            NG.
            OK

            10.CHECK IDLE SPEED AND MAXIMUM ENGINE SPEED

              NG.
              OK

              11.CHECK DIAGNOSTIC CIRCUIT

                NG.
                OK

                12.CHECK VACUUM PUMP

                  NG.
                  OK

                  ← CHECK FOR INTERMITTENT PROBLEMS (from Aug 2007)REGISTRATION (Nov 2005 – Dec 2006) →