2005-2008 RAV4 · Service Manual STEERING

REASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. INSTALL IGNITION SWITCH ASSEMBLY (w/o Entry and Start System)

C128812
  1. Attach the 2 claws to install the ignition switch onto the steering column bracket upper.


2. INSTALL KEY INTERLOCK SOLENOID (w/o Entry and Start System)

C128811
  1. for Automatic Transaxle:

    1. Install the key interlock solenoid onto the steering column bracket upper with the 2 screws.


3. INSTALL UNLOCK WARNING SWITCH ASSEMBLY (w/o Entry and Start System)

C128815
  1. Attach the 2 claws to install the unlock warning switch onto the steering column bracket upper.

    HINT:
    Slide the unlock warning switch assembly in the direction shown by the arrow in the illustration to install it.


4. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Entry and Start System)
  1. Turn the ignition switch on (ACC).

  1. C128816
    Install the ignition switch lock cylinder into the steering column bracket upper.

    HINT:
    Make sure that the ignition switch lock cylinder is securely fixed onto the steering column bracket upper.


5. INSPECT STEERING LOCK OPERATION (w/o Entry and Start System)

  1. C128817
    Remove the key and check that the steering lock function is activated.

  1. C128818
    Insert the key, turn the ignition switch on (ACC) and check that the steering lock function is deactivated.


6. INSTALL STEERING COLUMN UPPER W/SWITCH BRACKET ASSEMBLY (w/o Entry and Start System)
  1. Fix the steering column in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. C128831
    Install the steering column upper with switch bracket and steering column clamp upper with 2 new steering lock set bolts, and then tighten the bolts until their heads come off.


7. INSTALL TRANSPONDER KEY AMPLIFIER (w/o Entry and Start System)

C128820
  1. Attach the 2 claws and install the transponder key amplifier onto the steering column upper with the switch bracket.


8. INSTALL STEERING LOCK ACTUATOR ASSEMBLY (w/ Entry and Start System)
  1. Fix the steering column in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. C128831
    Install the steering lock actuator and steering column clamp upper with new steering lock set bolt, and then tighten the bolts until their heads come off.

← INSPECTION (from Nov 2005)INSTALLATION (Nov 2005 – Dec 2006) →