Removal / installation · Vehicles built from Nov 2005
1.
REMOVE NO. 1 ENGINE UNDER COVER
Remove the 4 bolts, 12 clips and engine under cover.
2.
DRAIN ENGINE COOLANT
Loosen the radiator drain cock plug.
HINT:
Collect the coolant in a container and dispose of it according to the regulations in your area.
Remove the radiator reservoir cap.
CAUTION:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
Loosen the cylinder block drain cock plug.
3.
REMOVE RADIATOR SUPPORT OPENING COVER
Remove the 2 clips.
Partially remove the radiator support opening cover.
HINT:
It is not necessary to fully remove the radiator support opening cover. Partially remove it so that the bumper cover can be removed later.
4.
REMOVE NO. 2 WATER BY-PASS HOSE
Loosen the 2 clips and remove the No. 2 water by-pass hose.
5.
DISCONNECT OUTLET RADIATOR HOSE
Loosen the clip and disconnect the outlet radiator hose.
6.
REMOVE NO. 4 INLET WATER BY-PASS PIPE
Remove the bolt and No. 4 inlet water by-pass pipe.