2005-2008 RAV4 · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 4 bolts, 12 clips and engine under cover.


2. DRAIN ENGINE COOLANT
  1. Loosen the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Remove the radiator reservoir cap.

    CAUTION:
    Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the cylinder block drain cock plug.

    A126839E01


3. REMOVE RADIATOR SUPPORT OPENING COVER

  1. B130259
    Remove the 2 clips.

  1. Partially remove the radiator support opening cover.

    HINT:
    It is not necessary to fully remove the radiator support opening cover. Partially remove it so that the bumper cover can be removed later.


4. REMOVE NO. 2 WATER BY-PASS HOSE

  1. A127741
    Loosen the 2 clips and remove the No. 2 water by-pass hose.


5. DISCONNECT OUTLET RADIATOR HOSE

  1. A126847E01
    Loosen the clip and disconnect the outlet radiator hose.


6. REMOVE NO. 4 INLET WATER BY-PASS PIPE

  1. A116608
    Remove the bolt and No. 4 inlet water by-pass pipe.


7. REMOVE WATER INLET

  1. A115182
    Remove the 3 bolts and water inlet.


8. REMOVE THERMOSTAT

  1. A117759
    Remove the thermostat.

  1. Remove the gasket from the thermostat.

← COMPONENTS (from Nov 2005)INSPECTION (from Nov 2005) →