2005-2008 RAV4 · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Nov 2005

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. REMOVE FRONT SEAT HEADREST ASSEMBLY

2. REMOVE FRONT SEAT ASSEMBLY
  1. Operate the power seat switch knob and move the seat to the foremost position.

  1. B139932
    Using a screwdriver, detach the 2 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the front seat track bracket outer cover in the direction indicated by the arrow in the illustration.

  1. B139935
    Using a screwdriver, detach the 2 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the front seat track bracket inner cover in the direction indicated by the arrow in the illustration.

  1. B131274
    Remove the 2 bolts on the rear side of the seat.

  1. B131273
    Operate the power seat switch knob and move the seat to the rearmost position.

  1. Remove the 2 bolts on the front side of the seat.

  1. Operate the power seat switch knob and move the seat to the center position. Then, operate the power seat switch knob and move the seatback to the upright position.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

  1. Disconnect the connectors under the seat.

  1. Remove the seat.

    NOTICE:
    Be careful not to damage the vehicle body.

← COMPONENTS (from Aug 2008)DISASSEMBLY (Nov 2005 – Dec 2006) →