2005-2008 RAV4 · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Aug 2007


1. REMOVE RADIATOR SUPPORT OPENING COVER

  1. A137899
    Remove the 9 clips and cover.


2. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Turn the A/C switch ON.

  1. Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Using SST, discharge the refrigerant gas.

    SST
    07110-58060   (07117-58060, 07117-58070, 07117-58080, 07117-58090, 07117-78050, 07117-88060, 07117-88070, 07117-88080)


3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

4. REMOVE V-BANK COVER SUB-ASSEMBLY

  1. A137900
    Detach the 3 clips and remove the V-bank cover.


5. DISCONNECT RADIATOR RESERVE TANK ASSEMBLY

  1. A178054
    Remove the 2 bolts and disconnect the reservoir tank.


6. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 2 bolts, 4 screw, 10 clips and under cover.


7. REMOVE REAR ENGINE UNDER COVER RH
  1. Remove the 2 clips and under cover.


8. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH

  1. A129514E01
    Remove the 4 bolts and reinforcement.


9. REMOVE V-RIBBED BELT

  1. A137895
    Rotate the tensioner pulley counterclockwise to loosen the belt tension. Then remove the V-ribbed belt.

  1. A095070E01
    While turning the belt tensioner counterclockwise, align its holes, and then insert a 5 mm bi-hexagon wrench into the holes to fix the V-ribbed belt tensioner in place.


10. REMOVE NO. 1 COOLER REFRIGERANT SUCTION HOSE

H102039
  1. Remove the bolt and disconnect the cooler refrigerant suction hose from the cooler compressor.

  1. Remove the O-ring from the cooler refrigerant suction hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.


11. REMOVE NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

H102036
  1. Remove the bolt and disconnect the cooler refrigerant discharge hose from the cooler compressor.

  1. Remove the O-ring from the cooler refrigerant discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.


12. REMOVE COOLER COMPRESSOR ASSEMBLY

  1. H102369
    Disconnect the connector.

  1. Remove the 4 bolts and cooler compressor.


13. REMOVE CRANKSHAFT POSITION SENSOR

  1. A106634
    Disconnect the sensor connector.

  1. Remove the bolt and sensor.

← COMPONENTS (from Aug 2007)INSPECTION (from Aug 2007) →