HYDRAULIC TEST
Troubleshooting · Vehicles built from Aug 2007
| PERFORM HYDRAULIC TEST |
![]() ![]() |
Measure the line pressure.
- NOTICE:
- Perform the test at the normal operating ATF temperature: 50 to 80°C (122 to 176°F).
- The line pressure test should always be performed with at least 2 people. One person should observe the condition of the wheels or wheel chocks while the other is performing the test.
- Be careful to prevent SST's hose from interfering with the exhaust pipe.
- This test must be performed after checking and adjusting the engine.
- Perform the test with the A/C OFF.
- When conducting the stall test, do not continue for more than 10 seconds.
- Perform the test at the normal operating ATF temperature: 50 to 80°C (122 to 176°F).
Warm up the ATF (Automatic Transmission Fluid).
Lift the vehicle up.
Remove the engine under cover.
Connect the intelligent tester to the DLC3.
Remove the test plug A on the transaxle case front left side and install SST.
- SST
- 09992-00095
(09992-00231, 09992-00271)
- NOTICE:
- There is a difference between the installation point of the D position and R position.
Start the engine.
Using intelligent tester, shift to D position and hold 3rd gear by active test, and measure the line pressure in idling.
Specified line pressure: Condition
D position kPa (kgf/cm2, psi)
Idling
372 to 412 kPa
(3.8 to 4.2 kgf/cm2, 54 to 60 psi)
Turn the ignition switch off.
Disconnect the connector of the transmission wire.
- HINT:
- Disconnect the connector only when performing the D position stall test.
Start the engine.
Firmly depress the brake pedal, shift to the D position, depress the accelerator pedal all the way down and check the line pressure while the stall test is performed.
Specified line pressure: Condition
D position kPa (kgf/cm2, psi)
Stall test
931 to 1,031 kPa
(9.5 to 10.5 kgf/cm2, 135 to 150 psi)
Turn the ignition switch off.
Remove SST, and install the test plug A.
Remove the test plug B, install SST and start the engine.
- SST
- 09992-00095
(09992-00231, 09992-00271)
Connect the transmission wire connector, depress the brake pedal firmly, shift to the R position and check the line pressure while the engine is idling and during the stall test.
Specified line pressure: Condition
R position kPa (kgf/cm2, psi)
Idling
672 to 742 kPa
(6.9 to 7.6 kgf/cm2, 97 to 108 psi)
Stall test
1,768 to 1,968 kPa
(18.0 to 20.0 kgf/cm2, 256 to 285 psi)
Remove SST, and install the test plug B.
Clear the DTC.
Evaluation: Problem
Possible cause
Measured values at all positions are higher than specified
- Shift solenoid valve SLT defective
- Regulator valve defective
Measured values at all positions are lower than specified
- Shift solenoid valve SLT defective
- Regulator valve defective
- Oil pump defective
- U/D (underdrive) direct clutch defective
Pressure is low when shift lever is on D only
- D position circuit fluid leak
- Forward clutch defective
Pressure is low when shift lever is on R only
- R position circuit fluid leak
- Reverse clutch defective
- 1st and reverse brake defective
- Shift solenoid valve SLT defective

