2005-2008 RAV4 · Service Manual TRANSMISSION

MANUAL SHIFTING TEST

Troubleshooting · Vehicles built from Nov 2005


MANUAL SHIFTING TEST
The purpose of this manual shifting test is to determine whether a problem is caused by either mechanical or electrical factors. Disconnecting the transmission wire disables electrically-controlled automatic gear shifting. In this case, operating the shift lever is the only way to shift the transaxle gear. If the gear is not changed by shift lever operation, it is assumed that there is a mechanical problem.

  1. C127583
    Turn the ignition switch off.

  2. Disconnect the transmission wire connector.

  3. Warm up the engine.

  4. Drive the vehicle.

  5. Shifting the shift lever in the order of L, 2, 3 and D position to check whether the shifting condition changes the table below.

    Standard: 
    Shift Position
    Shifting Condition
    L to 2
    No shift (Not change)
    2 to 3
    No shift (Not change)
    3 to D
    No shift (Not change)
    D to 3
    No shift (Not change)
    3 to 2
    No shift (Not change)
    2 to L
    No shift (Not change)

  6. Turn the ignition switch off.

  7. Connect the transmission wire connector.

  8. Clear DTCs (Click here).

HINT:
When the transmission wire is disconnected, the transaxle gear will be set as listed below.
Shift Position
Gear
P
Parking
R
Reverse
N
Neutral
D
3rd
3
3rd
2
3rd
L
3rd

← HYDRAULIC TEST (from Nov 2005)INITIALIZATION (from Nov 2005) →