2005-2008 RAV4 · Service Manual ENGINE

MIL Circuit

Circuit diagnosis · Vehicles built Jan 2007 – Jul 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007

DESCRIPTION

The MIL (Malfunction Indicator Lamp) is used to indicate vehicle malfunction detections by the ECM. When the ignition switch is turned on (IG), power is supplied to the MIL circuit, and the ECM provides the circuit ground which illuminates the MIL.
The MIL operation can be checked visually: When the ignition switch is first turned on (IG), the MIL should be illuminated and should then turn off. If the MIL remains illuminated or is not illuminated, conduct the following troubleshooting procedure using the intelligent tester.

WIRING DIAGRAM

A127775E01

INSPECTION PROCEDURE


1. CHECK THAT MIL IS ILLUMINATED
  1. Perform troubleshooting in accordance with the table below.

    Condition
    Proceed to
    MIL remains ON
    A
    MIL does not illuminate
    B



B
Go to step 5
A


2. CHECK WHETHER MIL TURNS OFF
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Select the following menu items: Powertrain / Engine and ECT / DTC.

  1. Check if any DTCs have been stored. Note down any DTCs.

  1. Clear DTCs (Click here).

  1. Check if the MIL goes off.

    Standard:
    MIL should go off.



OK
REPAIR CIRCUIT INDICATED BY OUTPUT DTC
NG


3. CHECK HARNESS AND CONNECTOR (CHECK FOR SHORT IN WIRE HARNESS)
A115671E06
  1. Disconnect the A12 ECM connector.

  1. Turn the ignition switch on (IG).

  1. Check that the MIL is not illuminated.

    OK:
    MIL is not illuminated.

  1. Reconnect the ECM connector.



OK
REPLACE ECM
NG


4. CHECK HARNESS AND CONNECTOR (COMBINATION METER - ECM)
A127855E02
  1. Disconnect the E22 combination meter connector.

  1. Disconnect the A12 ECM connector.

  1. Measure the resistance.

    Standard resistance (Check for short):
    Tester Connection
    Specified Condition
    W (A12-24) or EFI (E22-8) - Body ground
    10 kΩ or higher

  1. Reconnect the combination meter connector.

  1. Reconnect the ECM connector.



OK
REPAIR OR REPLACE COMBINATION METER ASSEMBLY
NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

5. CHECK THAT MIL IS ILLUMINATED
  1. Check if the MIL is illuminated when the ignition switch is turned on (IG).

    OK:
    MIL should be illuminated.



OK
SYSTEM OK
NG


6. CHECK THAT ENGINE STARTS
  1. Turn the ignition switch on (IG).

  1. Start the engine.

    Result
    Proceed to
    Engine starts
    A
    Engine does not start*
    B

    HINT:
    *: The intelligent tester cannot communicate with the ECM.



B
GO TO VC OUTPUT CIRCUIT
A


7. INSPECT COMBINATION METER ASSEMBLY (MIL CIRCUIT)
  1. Check the MIL circuit (Click here).



NG
REPAIR OR REPLACE COMBINATION METER ASSEMBLY
OK

CHECK AND REPLACE HARNESS OR CONNECTOR (COMBINATION METER - ECM)


← MIL Circuit (Nov 2005 – Dec 2006)MIL Circuit (from Aug 2007) →