2005-2008 RAV4 · Service Manual ENGINE

B2273 Ignition 2 Monitor Malfunction

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

This DTC is output when a malfunction occurs in the IG output circuit, which is between the IG2 relay actuation circuit inside the main body ECU and the IG2 relay.
DTC No.
DTC Detection Condition
Trouble Area
B2273
IG2 relay actuation circuit inside main body ECU or other related circuit is malfunctioning
  1. Main body ECU
  1. IG2 relay
  1. Wire harness

WIRING DIAGRAM

A126720E01

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (IG2 RELAY MONITOR (INSIDE))
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Select the following menu items: Body / Main Body ECU / Data List / IG2 Relay Mon2.

  1. Read the display on the tester.

    Main body ECU:
    Item
    Measurement Item / Display (Range)
    Normal Condition
    Diagnostic Note
    IG2 Relay Mon2
    IG2 inner relay monitor / ON or OFF
    ON: Ignition switch on (IG)
    OFF: Ignition switch off
    -

    OK:
    When the ignition switch is turned on (IG), ON is displayed on the tester.



NG
Go to step 3
OK


2. CHECK SWITCH CONDITION (IGNITION SWITCH)
  1. Ensure the electrical key is inside the cabin.

  1. Check that the power source mode changes as shown below each time the ignition switch is pushed.

OK:
off → on (ACC) → on (IG) → off



NG
GO TO POWER SOURCE MODE DOES NOT CHANGE
OK

NORMAL

3. INSPECT IG2 RELAY

  1. B060778E04
    Remove the IG2 relay from the engine room No. 1 relay block.

  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

  1. Reinstall the IG2 relay.



NG
REPLACE IG2 RELAY
OK


4. CHECK WIRE HARNESS (IG2 RELAY - MAIN BODY ECU AND BODY GROUND)

  1. A126726E02
    Remove the IG2 relay from the engine room No. 1 relay block.

  1. Disconnect the E19 main body ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    Relay block IG2 relay terminal 1 - E19-5 (IG2D)
    Below 1 Ω
    Relay block IG2 relay terminal 2 - Body ground
    Below 1 Ω
    Relay block IG2 relay terminal 1 or E19-5 (IG2D) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU)


← B2272 Ignition 1 Monitor Malfunction (from Nov 2005)B2274 ACC Monitor Malfunction (from Nov 2005) →