B2274 ACC Monitor Malfunction
Diagnostic trouble codes · Vehicles built from Nov 2005
DESCRIPTION
This DTC is output when a malfunction occurs in the ACC output circuit, which is between the ACC relay actuation circuit inside the main body ECU and the ACC relay.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2274 |
ACC relay actuation circuit inside main body ECU or other related circuit is malfunctioning |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (ACC RELAY MONITOR) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Select the following menu items: Body / Main Body ECU / Data List / ACC Relay Mon.
Read the display on the tester.
- Main body ECU:
Item
Measurement Item / Display (Range)
Normal Condition
Diagnostic Note
ACC Relay Monitor
ACC relay monitor / ON or OFF
ON: Ignition switch on (ACC)
OFF: Ignition switch off
-
- OK:
- When the ignition switch is turned on (ACC), ON is displayed on the tester
|
|
||||
| OK | |
| 2. CHECK SWITCH CONDITION (IGNITION SWITCH) |
Ensure the electrical key is inside the cabin.
Check that the power source mode changes as shown below each time the ignition switch is pushed.
- OK:
- off → on (ACC) → on (IG) → off
|
|
||||
| OK | ||
| ||
| 3. INSPECT ACC RELAY |
Remove the ACC relay from the instrument panel junction block.

Check the resistance of the relay.
- Standard resistance:
Tester Connection
Specified Condition
3 - 5
10 kΩ or higher
3 - 5
Below 1 Ω
(when battery voltage is applied to terminals 1 and 2)
|
|
||||
| OK | |
| 4. CHECK WIRE HARNESS (ACC RELAY - MAIN BODY ECU AND BODY GROUND) |
Remove the ACC relay from the No. 5 relay block.

Disconnect the E18 main body ECU connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connections
Specified Conditions
Relay block ACC relay terminal 1 - E18-4 (ACCD)
Below 1 Ω
Relay block ACC relay terminal 2 - Body ground
Below 1 Ω
Relay block ACC relay terminal 1 or E18-4 (ACCD) - Body ground
10 kΩ or higher
|
|
||||
| OK | ||
| ||
