2005-2008 RAV4 · Service Manual ENGINE

B2275 STSW Monitor Malfunction

Diagnostic trouble codes · Vehicles built from Jan 2007

DESCRIPTION

This DTC is output when the engine start request signal circuit inside the main body ECU is open or short.
DTC No.
DTC Detection Condition
Trouble Area
B2275
Engine start request signal circuit inside main body ECU or other related circuit is malfunctioning
  1. Main body ECU
  2. SFI system
  3. Wire harness or connector

WIRING DIAGRAM

A122229E24

INSPECTION PROCEDURE


1. CHECK WHETHER DTC OUTPUT RECURS
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG) and turn the tester ON.

  1. Clear the DTCs.

  1. Depress the brake pedal with the engine switch on (IG), wait at least 15 seconds, and check whether DTC B2275 recurs.

    Result:
    Display (DTC output)
    Proceed to
    B2275
    A
    No DTC output
    B



B
END
A


2. CHECK MAIN BODY ECU (STSW VOLTAGE)

  1. A122230E03
    Disconnect the E20 main body ECU connector.

  1. With the shift lever in P or N, depress the brake pedal fully.

  1. Measure the voltage according to the value(s) in the table below.

    HINT:
    The voltage is generated at terminal STSW for 0.3 seconds when the engine cranks.

    Standard voltage:
    Tester Connection
    Specified Condition
    E20-4 (STSW) - Body ground
    10 to 14 V



NG
Go to step 4
OK


3. CHECK WIRE HARNESS (MAIN BODY ECU - ECM)

  1. A126728E02
    Disconnect the E20 main body ECU connector.

  1. Disconnect the A12 ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    E20-4 (STSW) - A12-14 (STSW)
    Below 1 Ω
    E20-4 (STSW) or A12-14 (STSW) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK WHETHER ENGINE STARTS
  1. Temporarily replace the instrument panel junction block (main body ECU) with a new or normally functioning one.

  1. Check that the engine starts normally.

    OK:
    Engine starts normally.



NG
GO TO SFI SYSTEM
OK

END (MAIN BODY ECU IS FAULTY)


← B2274 ACC Monitor Malfunction (from Jan 2007)B2276 ACCR Signal Circuit Malfunction (from Jan 2007) →