2005-2008 RAV4 · Service Manual RESTRAINTS

CHECK MODE PROCEDURE

Troubleshooting · Vehicles built from Nov 2005


CHECK MODE (SIGNAL CHECK)

  1. B127990E01
    Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG).

  3. Select the "SIGNAL CHECK", continue checking with the intelligent tester.

    NOTICE:
    Select the "SIGNAL CHECK" from the "DTC CHECK" screen displayed on the intelligent tester to clear the output DTCs (both present and past).

    HINT:
    1. Check mode is more sensitive to malfunctions than normal mode.
    2. If the normal system code is output in normal mode even when a sensor signal malfunction is suspected, perform the inspection in check mode.

← DTC CHECK / CLEAR (from Jan 2007)DATA LIST / ACTIVE TEST (from Nov 2005) →