2005-2008 RAV4 · Service Manual ENGINE

Engine Switch Indicator Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

Engine start conditions or system malfunctions can be checked by observing the status of the engine switch indicator light.
Engine switch indicator light condition 
Power Source Mode/Condition
Indicator Light Condition
Clutch pedal released
Clutch pedal depressed
Off
OFF
Illuminates (green)
On (ACC, IG)
Illuminates (amber)
Illuminates (green)
Engine running
OFF
OFF
Steering lock not unlocked
Flashes (green) for 30 seconds
Flashes (green) for 30 seconds
System malfunction
Flashes (amber) for 15 seconds
Flashes (amber) for 15 seconds
Clutch start switch malfunction
Flashes (green) for 15 seconds
Flashes (green) for 15 seconds

WIRING DIAGRAM

A122428E02

INSPECTION PROCEDURE


1. INSPECT ENGINE SWITCH ASSEMBLY
A109259E07
  1. Remove the engine switch.

  1. Apply the battery voltage of the switch, and check the illumination condition of the engine switch indicator light.

    NOTICE:
    1. If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator light does not illuminate.
    2. If the voltage is too low, the indicator light does not illuminate.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 11 (SWIL)
    Battery negative (-) → Terminal 4 (COM) or 5 (GND)
    Illuminates
    Battery positive (+) → Terminal 12 (INDS)
    Battery negative (-) → Terminal 4 (COM) or 5 (GND)
    Illuminates
    Battery positive (+) → Terminal 13 (INDW)
    Battery negative (-) → Terminal 4 (COM) or 5 (GND)
    Illuminates



NG
REPLACE ENGINE SWITCH ASSEMBLY
OK


2. CHECK WIRE HARNESS (ENGINE SWITCH - MAIN BODY ECU AND BODY GROUND)
A122429E03
  1. Disconnect the E31 engine switch connector.

  1. Disconnect the E19 and E20 main body ECU connectors.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E31-11 (SWIL) - E19-8 (SWIL)
    Below 1 Ω
    E31-12 (INDS) - E20-1 (INDS)
    Below 1 Ω
    E31-13 (INDW) - E20-8 (INDW)
    Below 1 Ω
    E31-5 (GND) - Body ground
    Below 1 Ω
    E31-4 (COM) - Body ground
    Below 1 Ω
    E31-11 (SWIL) or E19-8 (SWIL) - Body ground
    10 kΩ or higher
    E31-12 (INDS) or E20-1 (INDS) - Body ground
    10 kΩ or higher
    E31-13 (INDW) or E20-8 (INDW) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU)


← Engine does not Start (from Nov 2005)COMPONENTS (from Nov 2005) →