B2286 Runnable Signal Malfunction
Diagnostic trouble codes · Vehicles built from Nov 2005
DESCRIPTION
The main body ECU and the ECM are connected by a cable and the CAN communication line. If the cable information and CAN information are inconsistent, this DTC is output.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2286 |
Cable and CAN information between main body ECU and ECM are inconsistent |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (ENGINE CONDITION) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Select the following menu items: Body / Main Body ECU / Data List / E/G Cond.
Read the display on the tester.
- Main body ECU:
Item
Measurement Item/Display (Range)
Normal Condition
Diagnostic Note
E/G Cond
Engine condition / RUN or STOP
RUN: Engine running
STOP: Engine stopped
-
- OK:
- When the engine is running, RUN is displayed on the tester.
|
|
||||
| NG | |
| 2. CHECK WIRE HARNESS (MAIN BODY ECU - ECM) |
Disconnect the E20 main body ECU connector.

Disconnect the A12 ECM connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
E20-2 (TACH) - A12-15 (TACH)
Below 1 Ω
E20-2 (TACH) or A12-15 (TACH) - Body ground
10 kΩ or higher
|
|
||||
| OK | |
| 3. CHECK WHETHER ENGINE STARTS |
Temporarily replace the main body ECU with a new or normally functioning one.
Check that the engine starts normally.
- OK:
- Engine starts normally.
|
|
||||
| OK | ||
| ||
