2005-2008 RAV4 · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Nov 2005

HINT:
Use high-temperature grease to lubricate the bearings, gears, return spring and steel ball when assembling the starter.


1. INSTALL PLANETARY GEAR

  1. A081656E01
    Apply grease to the planetary gears and pin parts of the planetary shaft.

  1. Install the 3 planetary gears.


2. INSTALL STARTER ARMATURE ASSEMBLY

  1. A082440E01
    Apply grease to the plate washer and the armature shaft.

  1. Install the starter armature to the starter commutator end frame.

  1. Using snap ring pliers, install the plate washer and a new snap ring.

  1. A058810E01
    Using a vernier caliper, measure the length of the snap ring.

    Maximum length:
    5.0 mm (0.197 in.)

    If the length is greater than the maximum, replace it with a new snap ring.


3. INSTALL STARTER COMMUTATOR END FRAME COVER

  1. A081178
    Install the end frame cover to the commutator end frame.


4. INSTALL STARTER ARMATURE PLATE

  1. A073991E04
    Insert the armature plate to the starter yoke.

  1. Align the keyway of the starter plate with the key inside the starter yoke, and install the starter plate.


5. INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY

  1. A079727E01
    Align the rubber of the end frame with the cutout of the starter yoke.

  1. Install the end frame to the starter yoke.


6. INSTALL STARTER YOKE ASSEMBLY

  1. A079728E01
    Align the protrusion of the starter yoke with the cutout of the starter drive housing.

  1. A079720
    Install the starter yoke with the 2 through-bolts.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }


7. INSTALL MAGNETIC SWITCH ASSEMBLY

  1. A079729
    Apply grease to the plunger and the hook.

  1. Hang the plunger hook of the magnetic switch to the drive lever.

  1. Install the plunger and return spring.

  1. A079719
    Install the magnetic switch with the 2 screws.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. A079718
    Connect the lead wire to the magnetic switch with the nut.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

← INSPECTION (from Nov 2005)INSTALLATION (from Nov 2005) →