2005-2008 RAV4 · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2007


1. INSPECT UNDERDRIVE PACK CLEARANCE

  1. D026429E01
    Install the underdrive clutch to the transaxle case.

    NOTICE:
    Be careful not to damage the oil seal rings.

  1. Install a dial indicator as shown in the illustration.

  1. Measure the underdrive clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).

    Standard pack clearance:
    1.51 to 1.71 mm (0.0594 to 0.0673 in.)

    If the pack clearance is not as specified, inspect the discs, plates and flange.

    HINT:
    There are 5 different thicknesses of flanges available.

    Standard flange thickness:
    Mark
    Thickness
    Mark
    Thickness
    1
    3.0 mm (0.118 in.)
    4
    3.6 mm (0.142 in.)
    2
    3.2 mm (0.126 in.)
    5
    3.8 mm (0.150 in.)
    3
    3.4 mm (0.134 in.)
    -
    -


2. REMOVE UNDERDRIVE CLUTCH FLANGE NO. 2 HOLE SNAP RING

  1. D003701E02
    Using a screwdriver, remove the snap ring.


3. REMOVE NO. 1 UNDERDRIVE CLUTCH DISC

  1. D026430E02
    Remove the flange, 4 discs and 4 plates from the underdrive clutch drum.


4. REMOVE UNDERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY

  1. D003703E02
    Place SST on the clutch balancer and compress the spring with a press.
    SST
    09350-32014  

  1. Using a snap ring expander, remove the snap ring.

    NOTICE:
    1. Stop the press when the spring seat is lowered to a position 1 to 2 mm (0.039 to 0.078 in.) from the snap ring groove. This prevents the spring seat from being deformed.
    2. Do not expand the snap ring excessively.

  1. C056359E02
    Remove the clutch balancer from the underdrive clutch drum.

  1. C056360E03
    Remove the return spring from the underdrive clutch drum.


5. REMOVE UNDERDRIVE CLUTCH PISTON SET

  1. D003705E01
    Install the underdrive clutch to the transaxle case.

    NOTICE:
    Be careful not to damage the oil seal ring.

  1. Holding the underdrive clutch piston by hand, apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) to the transaxle case to remove the underdrive clutch piston.


6. REMOVE UNDERDRIVE CLUTCH DRUM O-RING

  1. D026465E05
    Using a screwdriver, remove the O-ring from the underdrive clutch drum.

← COMPONENTS (from Aug 2007)INSPECTION (from Aug 2007) →