2005-2008 RAV4 · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built from Jan 2007

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. INSTALL FRONT SEAT ASSEMBLY
  1. Place the seat in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Connect the connector under the seat.

  1. Lift up the seat track adjusting handle and move the seat to the rearmost position.

  1. B131219E01
    Install the 2 bolts to the front side of the seat.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

    HINT:
    Tighten the bolts in the order indicated in the illustration.

  1. Lift up the seat track adjusting handle and move the seat to the foremost position.

  1. B131218E01
    Install the 2 bolts to the rear side of the seat.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

    HINT:
    Tighten the bolts in the order indicated in the illustration.


2. INSPECT AND ADJUST SEAT SLIDE ADJUSTER LOCKS
  1. During sliding operation of the front seat, check that the left and right adjusters move together smoothly and lock simultaneously.
    If the seat adjusters do not lock simultaneously, loosen the seat fixation bolts to adjust the adjuster's position.


3. INSTALL FRONT SEAT TRACK BRACKET OUTER COVER LH

  1. B137714
    Install the outer cover in the direction indicated by the arrow in the illustration and attach the 2 claws.


4. INSTALL FRONT SEAT TRACK BRACKET INNER COVER LH

  1. B137716
    Install the inner cover in the direction indicated by the arrow in the illustration and attach the 2 claws.


5. INSTALL FRONT SEAT HEADREST ASSEMBLY

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

7. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).


8. INSPECT FRONT SEAT ASSEMBLY
  1. w/ Seat Heater System:
    Check the seat heater operation.

    1. Turn the ignition switch on (IG).

    2. Push the seat heater switch ON.

    3. Wait 5 minutes or more and confirm that the seat surface becomes warm.

← INSTALLATION (Nov 2005 – Dec 2006)COMPONENTS (Nov 2005 – Jul 2008) →