Key Reminder Buzzer does not Sound
Circuit diagnosis · Vehicles built from Nov 2005
DESCRIPTION
The key reminder warning buzzer sounds when the driver side door is opened while the ignition switch is in the off or on (ACC) positions. The key reminder warning buzzer is activated when the main body ECU sends a key switch signal and driver side courtesy switch signal to the combination meter.- HINT:
- Since the key reminder warning system has functions that use CAN communication, first confirm that there is no malfunction in the communication system by inspecting the CAN communication functions in accordance with the "HOW TO PROCEED WITH TROUBLESHOOTING" procedures. Then, conduct the following inspection procedure.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (FRONT DOOR COURTESY LIGHT SWITCH) |
Check the Data List to ensure proper operation of the front door courtesy light switch.
- Main body ECU:
Item
Measurement Item / Display (Range)
Normal Condition
Diagnostic Note
D Door Courtesy SW
Driver side door courtesy switch signal / ON or OFF
ON: Driver side door is open
OFF: Driver side door is closed
-
- OK:
- "ON" (driver door is open) appears on the screen.
|
|
||||
| OK | |
| 2. READ VALUE USING INTELLIGENT TESTER (UNLOCK WARNING SWITCH) |
Check the Data List to ensure proper operation of the door unlock warning switch.
- Main body ECU:
Item
Measurement Item / Display (Range)
Normal Condition
Diagnostic Note
Key Unlock Warning SW
Unlock warning switch signal / ON or OFF
ON: Key is in ignition key cylinder
OFF: No key is in ignition key cylinder
-
- OK:
- "ON" (key is in ignition key cylinder) appears on the screen.
|
|
||||
| NG | |
| 3. INSPECT UNLOCK WARNING SWITCH ASSEMBLY |
Remove the unlock warning switch.

Measure the resistance of the switch.
- Standard resistance:
Tester Connection
Condition
Specified Condition
1 - 2
Not pushed
10 kΩ or higher
1 - 2
Pushed
Below 1 Ω
|
|
||||
| OK | |
| 4. CHECK WIRE HARNESS (UNLOCK WARNING SWITCH - MAIN BODY ECU) |
Disconnect the E9 switch connector.

Disconnect the IE junction block connector.
Measure the resistance between the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
E9-1 - IE-26 (KSW)
Below 1 Ω
E9-2 - Body ground
Below 1 Ω
|
|
||||
| OK | ||
| ||
| 5. INSPECT FRONT DOOR COURTESY LIGHT SWITCH (for Driver Side) |
Remove the courtesy light switch.

Measure the resistance of the switch.
- Standard resistance:
Tester Connection
Condition
Specified Condition
1 - Body ground
Not pushed (ON)
Below 1 Ω
1 - Body ground
Pushed (OFF)
10 kΩ or higher
|
|
||||
| OK | |
| 6. CHECK WIRE HARNESS AND CONNECTORS (FRONT DOOR COURTESY LIGHT SWITCH - MAIN BODY ECU) |
Disconnect the K8*1 or L4*2 switch connector.

Disconnect the IA junction block connector.
Measure the resistance between the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
K7-1 - IA-21 (DCTY)
Below 1 Ω
|
|
||||
| OK | ||
| ||
