Radio Broadcast cannot be Received (Bad Reception)
Circuit diagnosis · Vehicles built from Nov 2005
INSPECTION PROCEDURE
| 1. CHECK IF RADIO AUTO-SEARCH FUNCTIONS PROPERLY |
Perform the auto-search of the radio and check that it functions normally.
- OK:
- Radio auto-search functions normally.
|
|
||||
| NG | |
| 2. CHECK OPTIONAL COMPONENTS |
Check if the telephone antenna, and other optional components are installed.
- OK:
- Optional component(s) installed.
|
|
||||
| NG | |
| 3. CHECK ANTENNA FOR NOISE PRODUCTION |
With the ignition switch on (ACC), turn on the radio and choose the AM mode.
Place the tip of a screwdriver on the antenna and check that noise is heard from the speakers.
- OK:
- Noise is heard.
|
|
||||
| NG | |
| 4. CHECK RADIO RECEIVER ASSEMBLY (ANTENNA) |
Remove the antenna plug of the radio receiver.

With the radio receiver connector connected, turn the ignition switch on (ACC).
Turn on the radio and choose the AM mode.
Place a flat-head screwdriver or a piece of metal, such as a thin wire, on the antenna jack of the radio receiver. Check that noise is heard from the speakers.
- OK:
- Noise is heard.
|
|
||||
| OK | ||
| ||
