2005-2008 RAV4 · Service Manual BRAKE

TS and CG Terminal Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

If the vehicle is stationary during sensor check mode, speed sensor malfunctions cannot be detected. The vehicle must be driven for speed sensor malfunctions to be detected.

HINT:
Change to sensor check mode by connecting terminals TC and CG of the DLC3, and turning the ignition switch from off to on (IG).


WIRING DIAGRAM

C108882E12

INSPECTION PROCEDURE


1. CHECK WIRE HARNESS (DLC3 - SKID CONTROL ECU AND BODY GROUND)

  1. C108907E11
    Disconnect the A27 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E16-4 (CG) - Body ground
    Below 1 Ω
    E16-12 (TS) - A27-15 (TS)
    Below 1 Ω
    A27-15 (TS) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE BRAKE ACTUATOR ASSEMBLY


← TC and CG Terminal Circuit (from Aug 2007)PRECAUTION (Nov 2005 – Dec 2006) →