P0516 Battery Temperature Sensor Circuit Low
Diagnostic trouble codes · Vehicles built from Jan 2007
Also covers:
- P0517 Battery Temperature Sensor Circuit High
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
DESCRIPTION
The battery current sensor is installed on the battery negative terminal to detect battery temperature.A thermistor is integrated into the battery current sensor, and the resistance of the thermistor in the battery current sensor changes according to the battery temperature.
The resistance of the thermistor in the battery current sensor decreases as the battery temperature increases. The resistance increases as the temperature decreases.
The battery current sensor is connected to the ECM. The ECM supplies 5 V from the THB terminal to the battery current sensor through resistor R.
The battery current sensor and resistor R are connected in series. This results in changes in the voltage supplied from the THB terminal when the resistance changes according to the battery temperature.
The ECM determines the battery temperature according to changes of voltage. When the battery temperature is high, the ECM determines to reduce the amount of current supplied from the generator in order to protect the battery.


| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0516 |
Battery current sensor output value is 0.2 V or less for 0.5 seconds or more with the ignition switch on (IG) (1 trip detection logic) |
|
| P0517 |
Battery current sensor output value is 4.8 V or more for 0.5 seconds or more with the ignition switch on (IG) (1 trip detection logic) |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).
- HINT:
- If DTCs relating to different systems are output, and they share terminal E2 as their ground, check this ground circuit first.
| 1. INSPECT BATTERY CURRENT SENSOR |
Disconnect the B31 battery current sensor connector.

Measure the resistance of the battery current sensor.
- Standard resistance:
Tester Connection
Condition
Specified Condition
B31-1 (THB) - B31-4 (E2)
20 to 30°C (68 to 86°F)
1.5 to 2.5 kΩ
Reconnect the battery current sensor connector.
|
|
||||
| OK | |
| 2. CHECK WIRE HARNESS (BATTERY CURRENT SENSOR - ECM) |
Disconnect the B31 battery current sensor connector.

Disconnect the B32 ECM connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
B31-1 (THB) - B32-115 (THB)
Below 1 Ω
B31-4 (E2) - B32-93 (EIB)
Below 1 Ω
B31-1 (THB) or B32-115 (THB) - Body ground
10 kΩ or higher
B31-4 (E2) or B32-93 (EIB) - Body ground
10 kΩ or higher
Reconnect the battery current sensor connector.
Reconnect the ECM connector.
|
|
||||
| OK | ||
| ||
