2005-2008 RAV4 · Service Manual BRAKE

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2005

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedures listed below are for the LH side.


1. REMOVE FRONT DISC BRAKE PAD
  1. Remove the 2 disc brake pads.


2. REMOVE ANTI-SQUEAL SHIM
  1. Remove the shims from each pad.


3. REMOVE NO. 1 PAD WEAR INDICATOR PLATE
  1. Remove the indicator plates from the pads.


4. REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE
  1. Remove the 4 plates from the brake cylinder mounting.


5. REMOVE FRONT DISC BRAKE CYLINDER MOUNTING LH

  1. C127059
    Remove the 2 bolts and cylinder mounting.


6. REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN

  1. C127070
    Remove the 2 pins (upper and lower) from the mounting.


7. REMOVE FRONT DISC BRAKE CYLINDER SLIDE BUSH

  1. C127071E01
    Using a screwdriver, remove the slide bush from the pin (lower).

    NOTICE:
    Be careful not to damage the pin.

    HINT:
    Tap the screwdriver tip before use.


8. REMOVE FRONT DISC BRAKE BUSH DUST BOOT

  1. C127072
    Remove the 2 boots from the mounting.


9. REMOVE CYLINDER BOOT

  1. C127060E01
    Using a screwdriver, pry out the set ring and boot.

    NOTICE:
    Be careful not to damage the brake piston and cylinder.

    HINT:
    Tap the screwdriver tip before use.


10. REMOVE FRONT DISC BRAKE PISTON

  1. G033449E02
    Place a piece of cloth between the piston and disc brake cylinder.

  1. Apply compressed air to remove the piston from the disc brake cylinder.

    CAUTION:
    Do not place your fingers in front of the piston when applying compressed air.

    NOTICE:
    Be careful not to spatter the brake fluid.


11. REMOVE PISTON SEAL

  1. C127062E01
    Using a screwdriver, pry out the seal from the cylinder.

    NOTICE:
    Be careful not to damage the inner cylinder and piston seal groove.

    HINT:
    Tap the screwdriver tip before use.


12. REMOVE FRONT DISC BRAKE BLEEDER PLUG
  1. Remove the bleeder plug cap and bleeder plug from the cylinder.


13. REMOVE FRONT DISC

  1. C127063E01
    Put matchmarks on the disc and axle hub.

  1. Remove the disc.

← REMOVAL (from Aug 2008)INSPECTION (from Nov 2005) →