REMOVAL
Removal / installation · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
| 1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
![]() ![]() |
Remove the 2 screws.
Detach the 2 claws and remove the instrument panel under cover.
| 2. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Knee Airbag) |
![]() ![]() |
Remove the 4 bolts and driver side knee airbag.
Disconnect the connector.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
| 3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag) |
![]() ![]() |
Remove the 2 screws.
Using a screwdriver, detach the 8 claws and remove the lower instrument panel finish panel.
- HINT:
- Tape the screwdriver tip before use.
| 4. REMOVE INSTRUMENT PANEL SAFETY PAD COVER |
Remove the instrument panel (Click here).
| 5. DISCONNECT CLUTCH START SWITCH CONNECTOR (w/ Entry and Start System) |
Disconnect the clutch start switch connector.
Remove the nut and clutch start switch from the clutch pedal support.
| 6. DISCONNECT CLUTCH START CANCEL SWITCH CONNECTOR (w/ Cruise Control System) |
Disconnect the switch connector.
For 1AZ-FE, 2AZ-FE, refer to the following procedures (Click here).
For 2AD-FTV, 2AD-FHV, refer to the following procedures (Click here).
| 7. REMOVE CLUTCH PEDAL ASSEMBLY |
![]() ![]() |
Remove the 2 bolts, 2 nuts and clutch pedal.





