When the airbag cut-off switch is turned off, the passenger airbag OFF indicator illuminates. When the passenger airbag OFF indicator illuminates, both the front passenger airbag and the front passenger side front seat side airbag stop functioning.
WIRING DIAGRAM
INSPECTION PROCEDURE
1. CHECK SRS WARNING LIGHT
Turn the ignition switch on (IG), and check the SRS warning light condition.
OK:
The SRS warning light does not come on.
NG
CHECK FOR DTC
OK
2. CHECK CONNECTOR
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Check that the connectors are properly connected to the center airbag sensor and the airbag cut-off switch.
OK:
The connectors are properly connected.
NG
CONNECT CONNECTOR
OK
3. INSPECT AIRBAG CUT-OFF SWITCH
Disconnect the E68 passenger airbag manual cut-off switch connector.
Measure the resistance of the wire harness side connector.
Standard resistance:
Tester Connection
Switch Condition
Specified Condition
1 (PMC-) - 2 (PMC+)
OFF
80 to 120 Ω
1 (PMC-) - 2 (PMC+)
ON
320 to 480 Ω
NG
REPLACE AIRBAG CUT-OFF SWITCH
OK
4. CHECK INSTRUMENT PANEL WIRE (FOR OPEN)
Disconnect the instrument panel wire connector from the airbag cut-off switch.
Using a service wire, connect E68-1 (PMC-) and E68-2 (PMC+) of connector C.
NOTICE:
Do not forcibly insert the service wire into the terminals of the connector when connecting.
Measure the resistance of the wire harness side connector.
Standard resistance:
Tester Connection
Specified Condition
E49-11 (MSW+) - E49-12 (MSW-)
Below 1 Ω
NG
REPAIR OR REPLACE INSTRUMENT PANEL WIRE
OK
5. CHECK INSTRUMENT PANEL WIRE (FOR SHORT)
Disconnect the service wire from connector C.
Measure the resistance of the wire harness side connector.
Standard resistance:
Tester Connection
Specified Condition
E49-11 (MSW+) - E49-12 (MSW-)
1 MΩ or higher
NG
REPAIR OR REPLACE INSTRUMENT PANEL WIRE
OK
6. CHECK INSTRUMENT PANEL WIRE (TO B+)
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Turn the ignition switch on (IG).
Measure the voltage of the wire harness side connector.
Standard voltage:
Tester Connection
Specified Condition
E49-11 (MSW+)- Body ground
Below 1 V
E49-12 (MSW-) - Body ground
Below 1 V
NG
REPAIR OR REPLACE INSTRUMENT PANEL WIRE
OK
7. CHECK INSTRUMENT PANEL WIRE (TO GROUND)
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Measure the resistance of the wire harness side connector.