REMOVAL
Removal / installation · Vehicles built from Nov 2005
- HINT:
- Use the same procedures for the RH and LH sides.
- The procedures listed below are for the LH side.
- Use the same procedures for the RH and LH sides.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE REAR COMBINATION LIGHT ASSEMBLY |
Remove the 3 nuts and disconnect the connector.

Detach the clip and remove the light.

