2005-2008 RAV4 · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Nov 2005


1. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY

B136374
  1. Install the wiper motor with the 3 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. B131466
    Align the matchmarks on the crank arm and motor.

  1. Apply MP grease to the sliding parts of the wiper motor and the rod of the wiper link.

  1. Connect the rod of the wiper link to the wiper motor.


2. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

B133583
  1. Connect the connector and attach the clamp.

  1. Move the wiper motor and link in the direction shown by the arrow in the illustration to attach the wiper cushion to the body, and install the wiper motor and link.

  1. Install the 2 bolts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }


3. INSTALL COWL TOP VENTILATOR LOUVER

B131453
  1. Attach the 12 claws and install the louver.

  1. Install the 2 clips.


4. INSTALL FRONT FENDER TO COWL SIDE SEAL LH

E125248E01
  1. Attach the claw to install the front fender to cowl side seal.


5. INSTALL FRONT FENDER TO COWL SIDE SEAL RH

B133588
  1. Attach the claw to install the front fender to cowl side seal.


6. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH

  1. E058837E07
    Stop the wiper motor at the automatic stop position.

  1. Clean the wiper arm serration with a round file or equivalent.

  1. Clean the wiper pivot serration with a wire brush.

  1. B133593E01
    Install the arm and blade with the nut. Make sure that the arm and blade comes to the position shown in the illustration.

    Torque:
    26 N*m{ 265 kgf*cm , 19 ft.*lbf }

    HINT:
    Hold down the arm hinge with your hand while tightening the nut.


7. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH

  1. E058837E07
    Clean the wiper arm serration with a round file or equivalent.

  1. Clean the wiper pivot serration with a wire brush.

  1. B133594E01
    Install the arm and blade with the nut. Make sure that the arm and blade comes to the position shown in the illustration.

    Torque:
    26 N*m{ 265 kgf*cm , 19 ft.*lbf }

    HINT:
    Hold down the arm hinge with your hand while tightening the nut.

  1. Operate the front wipers while spraying water or washer fluid on the windshield. Ensure that there is no interference between the blades and pillar.


8. INSTALL FRONT WIPER ARM HEAD CAP
  1. Install the 2 caps.


9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
← INSPECTION (from Nov 2005)COMPONENTS (from Nov 2005) →