2005-2008 RAV4 · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE FRONT WIPER ARM HEAD CAP
  1. Remove the 2 caps.


3. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH

B131452
  1. Remove the nut and arm and blade.


4. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH

B131474
  1. Remove the nut and arm and blade.


5. REMOVE FRONT FENDER TO COWL SIDE SEAL LH

E125248E01
  1. Detach the claw and remove the front fender to cowl side seal.


6. REMOVE FRONT FENDER TO COWL SIDE SEAL RH

B133588
  1. Detach the claw and remove the front fender to cowl side seal.


7. REMOVE COWL TOP VENTILATOR LOUVER

B131453
  1. Remove the 2 clips.

  1. Detach the 12 claws and remove the louver.


8. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

B131454E01
  1. Remove the 2 bolts.

  1. Move the wiper cushion in the direction shown by the arrow in the illustration to detach the wiper cushion from the body, and remove the wiper motor and link.

  1. Disconnect the connector and detach the clamp.


9. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY

  1. B136373
    Using a screwdriver, disconnect the rod of the wiper link from the wiper motor as shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.

  1. B131466
    Put matchmarks on the crank arm and motor, as shown in the illustration.

  1. B136374
    Remove the 3 bolts and wiper motor.

← COMPONENTS (from Nov 2005)INSPECTION (from Nov 2005) →