2005-2008 RAV4 · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Aug 2008

Versions by build date: Nov 2005 – Jul 2008 from Aug 2008


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


2. REMOVE RADIATOR SUPPORT OPENING COVER

B209240
  1. Remove the 9 clips and radiator support opening cover.


3. REMOVE CENTER HOOD CUSHION

  1. B209173
    Using a clip remover, remove the center hood cushion.


4. REMOVE RADIATOR GRILLE PROTECTOR

B209174
  1. Remove the 2 radiator grille protectors.


5. REMOVE FRONT FENDER FRONT SPLASH SHIELD LH

B208332
  1. Remove the screw, bolt, nut and splash shield.


6. REMOVE FRONT FENDER FRONT SPLASH SHIELD RH

HINT:
Use the procedure described for the LH side.


7. REMOVE FRONT FENDER LINER LH

  1. B133187
    Using a screwdriver, remove the clip and fender liner retainer.

  1. Remove the screw, nut and bolt.

  1. Partially remove the fender liner.

    HINT:
    It is not necessary to fully remove the fender liner. Partially remove it so that the bumper cover can be removed later.


8. REMOVE FRONT FENDER LINER RH

HINT:
Use the same procedures described for the LH side.


9. REMOVE FRONT BUMPER COVER

B208302
  1. Using a screwdriver, turn the pin hold clip 90° and remove the pin hold clip.

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedure for the RH and LH sides.

  1. Remove the retainer.

    HINT:
    Use the same procedure for the RH and LH sides.

  1. B209171E01
    Put protective tape around the bumper cover.

  1. Using a clip remover, remove the 4 clips.

  1. Remove the 8 screws.

  1. B208306
    Detach the 4 claws and remove the bumper cover.

  1. w/ Fog Light:
    Disconnect the 2 fog light connectors.


10. REMOVE WASHER INLET SUB-ASSEMBLY

  1. B133130
    Remove the clip.

  1. B133122
    Pull the washer inlet of the washer jar upward to remove it from the windshield washer jar.


11. DRAIN WASHER FLUID
  1. Remove a washer hose from either of the washer motor and pumps , and drain the washer fluid.


12. REMOVE WINDSHIELD WASHER JAR ASSEMBLY

  1. E173462
    Detach the 3 clamps.

  1. E173461
    Disconnect the 2 connectors.

  1. Remove the 2 washer hoses from the washer motor and pumps.

  1. Remove the 3 screws. Then remove the washer jar.


13. REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

B133124E01
  1. Remove the washer motor and pump from the packing of the washer jar.


14. REMOVE REAR WASHER MOTOR AND PUMP ASSEMBLY

B133125E01
  1. Remove the washer motor and pump from the packing of the washer jar.

← REMOVAL (Nov 2005 – Jul 2008)INSPECTION (from Nov 2005) →