DTC CHECK / CLEAR
Troubleshooting · Vehicles built from Nov 2005
| CHECK DTC |
![]() ![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the intelligent tester ON.
Select the following menu items: Body / Body ECU / DTC.
Check DTCs and then write them down.
- HINT:
- If you need help when using the intelligent tester, refer to the instruction manual.
Confirm the details of the DTCs.
| CLEAR DTC (Using Intelligent Tester) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) (do not start the engine) and turn the intelligent tester ON.
Select the following menu items: Body / Body ECU / DTC / Clear.
- HINT:
- Refer to the intelligent tester operator's manual for further details.
Erase DTCs by pressing the YES button on the tester.
- HINT:
- If you need help when using the intelligent tester, refer to the instruction manual.
| CLEAR DTC (Without Using Intelligent Tester) |
Remove the ECU-B fuse from the engine room No. 2 relay block for more than 60 seconds, or disconnect the cable from the negative (-) battery terminal for more than 60 seconds. If disconnecting the cable from the negative (-) battery terminal, perform the "INITIALIZE" procedure.

