2005-2008 RAV4 · Service Manual BODY ELECTRICAL

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Nov 2005


REMOVE ENGINE ROOM NO. 1 RELAY BLOCK COVER

INSPECT INTEGRATION RELAY (UNIT A: HORN RELAY)

A124942
  1. Using a screwdriver, detach the 2 claws and disconnect the integration relay from the engine room junction block.

    HINT:
    Tape the screwdriver tip before use.

  1. B128358E02
    Measure the resistance of the integration relay.

    Standard voltage:
    Tester Connection
    Specified Condition
    1A-8 - 1C-1
    10 kΩ or higher
    1A-8 - 1A-5
    1A-8 - 1C-1
    Below 1 Ω (when battery voltage is applied to terminals 1A-7 and 1A-6)
    1A-8 - 1A-5

    If the result is not as specified, replace the integration relay.


INSTALL ENGINE ROOM NO. 1 RELAY BLOCK COVER
← PROBLEM SYMPTOMS TABLE (from Nov 2005)COMPONENTS (Nov 2005 – Jul 2008) →