INSPECTION
Inspection · Vehicles built from Nov 2005
| INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY |
Measure the resistance of the switch.

- Standard resistance:
Tester Connection
Switch Condition
Specified Condition
4 (TB) - 1 (E)
OFF (Not pushed)
10 kΩ or higher
4 (TB) - 1 (E)
ON (Pushed)
Below 23.4 Ω
Inspect the switch illumination.
Connect the battery positive (+) lead to terminal 3 (ILL+) and the negative (-) lead to terminal 2 (ILL-), then check that the light comes on.
- OK:
- LED comes on.
